Material Safety Data Sheet Sikaflex®- 265 |
 |
|
|
| |
NOT CLASSIFIED AS HAZARDOUS ACCORDING TO CRITERIA OF WORKSAFE AUSTRALIA
COMPANY DETAILS
COMPANY: Sika (NZ) Ltd
ADDRESS: 85-91 Patiki Road, Avondale, Auckland
TELEPHONE: (09) 828 7002
EMERGENCY AFTER HOURS: 0800 734 607
FAX NUMBER: (09) 828 4091 |
| |
| |
| IDENTIFICATION |
| |
PRODUCT NAME: Sikaflex®- 265
OTHER NAMES: Not relevant
MANUFACTURER'S PRODUCT CODE: None allocated
U.N. NUMBER: None allocated
DANGEROUS GOODS CLASS AND
SUBSIDIARY RISK: None allocated
HAZCHEM CODE: None allocated
POISONS SCHEDULE NUMBER: None allocated
USE: Packed in 310ml cartridges or 600ml ssgs.
Elastomeric adhesive used in bus building.
|
| |
PHYSICAL DESCRIPTION/PROPERTIES:
APPEARANCE: Highly thixotropic, black tacky material. Cured by reaction with
moisture in the air to an elastic rubber like material.
BOILING POINT/MELTING POINT: Not applicable
VAPOUR PRESSURE: < 8 hPa
SPECIFIC GRAVITY: 1.26 approximately @ 20°C
FLASHPOINT: 63.50°C
FLAMMABILITY LIMITS: Not applicable
SOLUBILITY IN WATER: Insoluble |
| |
| |
| OTHER PROPERTIES: |
| |
| INGREDIENTS: |
| |
Chemical Name: |
CAS Number: |
Proportion: |
Polyurethane Prepolymer |
- |
30-40% |
Plasticiser |
- |
5-15% |
| Polyols |
- |
5-20% |
Xylene |
1330-20-7 |
1-3% |
Calcium Oxide |
- |
<1% |
Titanium Dioxide |
13463-67-7 |
<1% |
| IPDI/MDI traces |
4098-71-9/5124-30-1 |
<0.5% |
| PVC Filler |
- |
to 100% |
|
| |
| |
| HEALTH HAZARD INFORMATION |
| |
HEALTH EFFECTS:
Acute
Swallowed: Harmful - seek immediate medical advice.
Eye: Potentially serious - seek medical advice.
Skin: Mild irritant due to solvent - avoid contact.
Inhaled: No hazard in general use, good ventilation required in confined
spaces.
Chronic: Potential skin sensitiser due to xylene.
FIRST AID:
Swallowed: Do not induce vomiting - seek medical attention.
Eye: Immediately hold eyes open - wash with copious quantities of
water for a t least 15 minutes and seek medical attention.
Skin: Remove affected clothing and thoroughly wash affected area
with soap and water.
Inhaled: Not normally a hazard but if overcome remove to fresh air and
resuscitate as necessary - seek medical attention.
First Aid Facilities:
ADVICE TO DOCTOR: In all cases of ingestion, seek advice from 0800 734 607. |
| |
| |
| PRECAUTIONS FOR USE |
| |
EXPOSURE STANDARDS: Isocyanates (all as - NCO)
0.02 mg / m³ TWA 0.07 mg / m³ STEL
Xylene 80ppm TWA 150ppm STEL
ENGINEERING CONTROLS: Local ventilation not normally necessary but should be
considered if used in poorly ventilated or very confined spaces
alternatively a respiratory protection mask fitted with a type A1
filter and complying with AS/NZS 1716 Respiratory Devices
and used in accordance with AS/NZS 1715 which describes
use and maintenance.
PERSONAL PROTECTION: Neoprene or nitrile rubber gloves are recommended if
prolonged and extensive skin contact likely.
Do not store or consume food, drink or tobacco in an area
where they may become contaminated with this material.
Wash thoroughly before eating, smoking, applying cosmetics
etc.
FLAMMABILITY: Not flammable under conditions of use in well ventilated areas.
The product will burn if exposed to direct flame. A fire will
cause the decomposition of the polyurethane causing the
production of carbon dioxide, carbon monoxide, hydrogen
chloride and oxides of nitrogen. Under certain combustion
conditions traces of hydrogen cyanide gas may be generated.
Self contained breathing apparatus is recommended when
fighting fires involving large quantities of Sikaflex. |
| |
| |
| SAFE HANDLING INFORMATION |
| |
STORAGE & TRANSPORT: Storage between 0°C and 30°C is recommended. Above
45°C material may polymerise without hazard. Protect from
moisture and extremes of temperature.
SPILLS & DISPOSAL: NOT OF SPILLABLE CONSISTENCY
Clean up with cloth or tissue moistened with white spirits or
allow to cure and remove mechanically. Dispose of at an
approved landfill waste disposal site when fully cured.
FIRE/EXPLOSION HAZARD: Fight fires with foam, CO² or dry chemical extinguishers. Do
not use water. Produces oxides of nitrogen and under certain
combustion conditions traces of hydrogen cyanide could be
evolved.
OTHER INFORMATION: Persons known to be hypersensitive (asthma, chronic
bronchitis) should not use this product.
CONTACT POINT: Operations Manager (09) 828 7002 or (09) 820 1432. |
| |
|
|
